179
12.3 Error messages
Message on the display Cause Repair
Stitch number unknown.
> Check the entry and enter the new number.
Selection of the stitch pattern not
possible in the combi mode.
> Combine other stitches.
The feed dog is not lowered.
> Push the button «Feed dog up/down» to lower the feed
dog.
The selected needle and stitch
plate cannot be used in
combination.
> Replace the needle.
> Replace the stitch plate.
The needle is not at its top end.
> Adjust the needle position via the handwheel.
The upper thread is used up.
> Rethread.
The upper thread has broken.
> Rethread.
The bobbin thread is used up.
> Rethread.
The bobbin thread has broken.
> Clean the hook.
> Rethread.
035964.50.04_2014-08_Manual_B790_EN
To Next Page
Loading...
