Bernina 790 - Programming the Button Pattern End; Programming the Button Thread Cutter

Setup-Program
54
> Touch the icon «Sewing settings».
> Touch the icon «Programming buttons and icons».
> Touch the icon «Programming hovering height of the presser foot».
> Turn the «Upper Multifunctional knob» or the «Lower Multifunctional knob» or touch the icons «-» and
«+» to determine the distance between the fabric and the presser foot.
> Touch the yellow-framed icon to reset the alteration to basic setting.
Programming the button «Pattern end»
> Touch the icon «Setup Program» .
> Touch the icon «Sewing settings».
> Touch the icon «Programming buttons and icons».
> Touch the icon «Programming the button Pattern end».
> Touch the icon «Securing» to sew 4 securing stitches in place.
> Touch the icon «Altering the number of securing stitches» to program sequenced securing stitches.
> Touch the icons «-» and «+» to program the number of the sequenced securing stitches.
> Touch the yellow-framed icon to reset the alteration to basic setting.
> Touch the icon «Securing stitches in place» to program 4 securing stitches in place.
> Touch the icon «Thread cut» to deactivate the automatic thread cut after securing.
> Touch the icon «Thread cut» again to activate the automatic thread cut after securing.
> Touch the icon «Positioning the presser foot» to raise the presser foot after securing.
> Touch the icon «Positioning the presser foot» again to raise the presser foot after securing.
> Touch the icon «Securing» to deactivate the automatic securing.
> Touch the icon «Securing» again to activate the automatic securing.
Programming the button «Thread cutter»
> Touch the icon «Setup Program».
035964.50.04_2014-08_Manual_B790_EN