BERNINA Stitch Regulator (BSR)
138
> Insert the cable of the BSR presser foot into the connection (1).
1
> Switch the machine on.
– The BSR display opens and the BSR 1 mode is activated.
Changing the presser foot sole
NOTICE
The lens of the BSR presser foot is dirty.
The machine doesn't recognize the BSR presser foot.
> Clean the lens with a soft, slightly damp cloth.
The basic stitch length is 2 mm. When sewing small shapes and stippling it is recommended to shorten the
stitch length to 1 – 1.5 mm.
> Raise the needle.
> Raise the presser foot.
> Switch the machine off and disconnect it from the power supply system.
> Remove the presser foot (see page 40).
> Press both push buttons at the BSR foot against each other.
035964.50.04_2014-08_Manual_B790_EN
To Next Page
Loading...
