Bernina 790 - Embroidering Via the Foot Control; Creating Lettering

Embroidery
168
11.13 Embroidering via the foot control
Embroidering via the foot control is recommended when only a short sequence has to be embroidered.
While embroidering, the foot control must be pressed down all the time.
> Press the foot control to start embroidering.
– The embroidery machine embroiders ca. 7 stitches and stops automatically.
> Release the foot control.
> Raise the Embroidery foot.
> Cut the thread ends at the start according to the animation.
> Press the foot control and resume embroidering.
11.14 Creating lettering
Lettering is always embroidered in one color. To embroider single letters or single words in another color,
every letter or every word has to be selected individually and placed in the embroidering area.
Lettering can be positioned within the hoop as you like. When the embroidery motif is positioned outside the
embroidering area, the hoop is outlined in red on the display. With the hoop selection it can be checked
whether or not the embroidery motif can be embroidered in another hoop. When the lettering does not fit in
any hoop, two single words can be combined and positioned below each other as the following example will
show.
> Select the file «Alphabets».
> Select the font.
> Enter the text «Made to».
> Touch the icon (1) (standard setting), to use upper case letters.
> Touch the icon (2) to use lower case letters.
> Touch the icon (3) to use numbers and mathematic characters.
> Touch the icon (4) to use special characters.
3
1
2 4
>
Touch the icon «DEL» to delete single letters of the entered text.
> Touch the icon «Confirm» to accept the text.
> Touch the icon «Hoop display/Hoop selection».
> Select the hoop.
> Touch the icon «Hoop display/Hoop selection» again to go back to the Edit Mode.
> Touch the icon «i»-Dialog.
DE
L
DEL
035964.50.04_2014-08_Manual_B790_EN