Bernina 790 - Calibrating the Display; Back to Basic Setting

Setup-Program
63
> Touch the icon «Display settings».
> Move the slide in the lower portion of the display using the touchscreen pen or the finger to alter the
brightness of the sewing light.
> Touch the yellow-framed icon to reset the alteration to basic setting.
> Touch the switch to switch the sewing light off.
> Touch the switch again to switch the sewing light on.
Calibrating the display
> Touch the icon «Setup Program».
> Touch the icon «Machine settings».
> Touch the icon «Calibrating the display».
> Touch the crosses in sequence using the touchscreen pen.
Back to basic setting
> Touch the icon «Setup Program».
> Touch the icon «Machine settings».
> Touch the icon «Basic setting».
> Touch the icon «Basic setting Sewing».
> Touch the icon «Confirm» to restore basic settings for the sewing settings.
> Touch the icon «Basic setting Embroidering».
> Touch the icon «Confirm» to restore basic settings for the embroidery settings.
> Touch the icon «Basic setting all».
> Touch the icon «Confirm» to restore all the basic settings.
035964.50.04_2014-08_Manual_B790_EN