Bernina 790 - Monitoring Functions; Activating the Upper Thread Indicator; Activating the Bobbin Thread Indicator; Activating the Audio Signals

Setup-Program
61
3.4 Monitoring functions
Activating the upper thread indicator
> Touch the icon «Setup Program».
> Touch the icon «Monitoring settings».
> Touch the switch in the upper portion of the display to deactivate the upper thread indicator.
> Touch the switch again to activate the upper thread indicator.
Activating the bobbin thread indicator
> Touch the icon «Setup Program».
> Touch the icon «Monitoring settings».
> Touch the switch in the lower portion of the display to deactivate the bobbin thread indicator.
> Touch the switch again to activate the bobbin thread indicator.
3.5 Activating the audio signals
> Touch the icon «Setup Program».
> Touch the icon «Audio signals».
> Touch the switch (1) to deactivate any audio signals in general.
> Touch the switch (1) again to activate any audio signals in general.
> In the section (2) touch the icons «1 – 4» to set up the desired signal for the selection of a stitch pattern.
> In the section (2) touch the icon «Loudspeaker» to deactive the signal for the selection of a stitch pattern.
> In the section (2) touch the icon «Loudspeaker» again to active the signal for the selection of a stitch
pattern.
> In the section (3) touch the icons «1 – 4» to activate the signal for the selection of functions.
> In the section (3) touch the icon «Loudspeaker» to deactivate the signal for the selection of functions.
> In the section (3) touch the icon «Loudspeaker» again to activate the signal for the selection of functions.
> In the section (4) touch the icon «Loudspeaker» to deactivate the signal when using the BSR modes.
035964.50.04_2014-08_Manual_B790_EN