Preparation
49
> Wind the thread clockwise two to three times around the empty bobbin (3).
1
2
3
> Pull the excess thread over the thread cutter at the engaging lever and cut.
> Push the engaging lever towards the bobbin.
– The machine winds and the display to wind the bobbin appears.
> Move the slide on the display using the touchscreen pen or the finger to adjust the winding speed.
> Push the engaging lever to the right to stop the winding process.
> Push the engaging lever towards the bobbin again to continue the winding process.
– As soon as the bobbin is full, the machine stops the winding process automatically.
> Remove the bobbin and cut the thread using the thread cutter at the engaging lever.
Threading the bobbin thread
> Raise the needle.
> Switch the machine off.
> Open the bobbin cover.
035964.50.04_2014-08_Manual_B790_EN
To Next Page
Loading...
