Bernina 790 - Adjusting the Presser Foot Position with Needle Stop down; Programming the Button Quick Reverse

Setup-Program
55
> Touch the icon «Sewing settings».
> Touch the icon «Programming buttons and icons».
> Touch the icon «Programming the button Thread cutter».
> Touch the icon «Securing» to sew 4 securing stitches in place.
> Touch the icon «Changing the number of securing stitches» to enter the number of the sequenced
securing stitches.
> Touch the icons «-» and «+» to enter the number of the sequenced securing stitches.
> Touch the yellow-framed icon to reset the alteration to basic setting.
> Touch the icon «Securing stitches in place» to program 4 securing stitches in place.
> Touch the icon «Securing» to deactivate the automatic securing.
> Touch the icon «Securing» again to activate the automatic securing.
Adjusting the presser foot position with needle stop down
With lowered needle, 3 different presser foot position can be selected: the presser foot lowered, the presser
foot is raised to hovering position and the presser foot is raised to its maximum height.
> Touch the icon «Setup Program».
> Touch the icon «Sewing settings».
> Touch the icon «Programming buttons and icons».
> Touch the icon «Adjusting the presser foot position with needle stop down».
> Select the desired presser foot position.
Programming the button «Quick reverse»
> Touch the icon «Setup Program».
> Touch the icon «Sewing settings».
035964.50.04_2014-08_Manual_B790_EN