132
• The Darning foot No. 9 (optional accessory) or the Button sew-on foot No. 18 (optional accessory) is
attached.
> Lower the feed dog.
> Select the Button sew-on Program No. 60.
> Place the button on the sewing project.
> Turn the handwheel to adjust the distance between the holes.
> Hold the threads when starting to sew and, if necessary, alter the stitch width.
– The machine sews the Button sew-on Program and stops automatically.
> Pull on both bobbin threads until the ends of the upper threads are visible on the wrong side.
> Knot the ends manually.
8.17 Sewing eyelets
For increased stability sew the eyelet twice.
Prerequisite:
• The Reverse pattern foot No. 1C or the Open embroidery foot No. 20C is attached.
> Select the Eyelet Program No. 61 or No. 62.
> Turn the «Upper Multifunctional knob» or the «Lower Multifunctional knob» to alter the size of the
eyelet.
> Sew the Eyelet Program.
– The machine stops automatically at the end of the Eyelet Program.
> Use an awl, punch pliers or a hole punch to open the eyelet.
035964.50.04_2014-08_Manual_B790_EN
To Next Page
Loading...
