BERNINA Stitch Regulator (BSR)
139
> Pull the presser foot sole out of the guide downwards.
> Insert the new presser foot sole into the guide and push upwards until it clicks into place.
> Attach the BSR presser foot (see page 137).
10.7 Securing
Securing in BSR1 mode with the button «Start/Stop»
Prerequisite:
• The BSR presser foot is attached and connected with the machine.
• The BSR display is opened and the BSR1 mode is activated.
> Lower the feed dog.
> Lower the presser foot.
> Press the button «Needle up/down» twice.
– The bobbin thread is brought up.
> Hold the upper and the bobbin thread.
> Press the button «Start/Stop».
– Start the BSR mode.
> Sew 5 – 6 securing stitches.
> Press the button «Start/Stop».
– The BSR mode stops.
> Cut the thread.
Securing in BSR2 mode
Prerequisite:
• BSR presser foot is attached and connected with the machine.
• The BSR display is open and the BSR2 mode is activated.
> Lower the presser foot.
> Press the button «Securing».
> Press the foot control or the button «Start/Stop».
By moving the fabric some short securing stitches are sewn, then the programmed stitch length is activated
and the securing function is deactivated automatically.
035964.50.04_2014-08_Manual_B790_EN
To Next Page
Loading...
