On the ATEM 1 M/E Advanced Panel,
press the ‘network’ LCD soft button
to open the network settings on the
LCD, then use the system control
arrow buttons to navigate to the
switcher IP address setting. Use
the soft controls to set the network
IP address for your switcher, and
don’t forget to save the changes.
NOTE Changing the switcher IP address on your panel does not change the
IP address of ATEM Mini itself. It just changes where the control panel is looking to find
the switcher.
ATEM Software Control via the Network
Lastly, if you want to use ATEM Software Control as well as an ATEM 1 M/E Advanced Panel,
you need to ensure your computer is connected and working on your network. Once launched,
if ATEM Software Control cannot communicate with ATEM Mini, you will be prompted
automatically to select your ATEM Mini from the connected ATEMs list, or enter the unit’s
IP address manually. Once you have confirmed the switcher from the list or set the IP address,
ATEM Software Control can find your switcher and communicate.
Multiple computers can run ATEM Software Control simultaneously, which means multiple operators can
be dedicated to separate controls on your switcher, for example media management and audio mixing.
108Connecting to a Network
To Next Page
Loading...
Need help?
General
