The connection process is fast because all the network settings for each ATEM unit have a
different default IP address when shipped from the factory. This means when you connect them
all to each other, their network settings are automatically configured and will work straight away.
However, if you are adding a camera control panel to an already existing system, or you need
tomanually assign a different IP address to avoid potential conflicts on your network, you can
enable DHCP so your panel determines the best IP address, or disable DHCP and set the
IP address manually.
NOTE ATEM Mini Pro and Extreme switchers don’t have a fixed IP address because it
is designed to use the DHCP. When connecting these switchers directly to ATEM
Camera Control Panel, we recommend setting a manual IP address.
When connecting to the camera control panel and a network, set the switcher to
DHCP. The network server will assign an IP address and you can then set that as the
camera control panel’s switcher IP address so it can communicate with your switcher.
You can read more about this in the following section.
For more information about setting ATEM Mini Pro and Extreme switcher’s network
settings refer to the ‘connecting to a network’ section.
Changing Network Settings
Changing network settings means manually setting the panel’s IP address so it can join your
network, then entering the switcher’s IP address on your panel so the switcher can be identified
by your panel. These settings are located in your camera control panel’s ‘settings’ LCD menu.
The home screen is the first menu item you will see on the CCU’s LCD. To access the network
settings, press the ‘settings’ soft button.
SETTINGS RECALL ALLBANK A
CAMERA CONTROL
Camera 1
1
CAMERA
SETTINGS RECALL ALLBANK A
CAMERA CONTROL
Camera 1
1
CAMERA
Press the ‘settings’ soft button
on the LCD home screen
toaccess all the camera
control panel’s settings
The DHCP setting is the first setting in the sequence of menu pages. Under this setting is a row
of small dot icons. As you press the arrow soft button to navigate through the pages of settings,
the dot icons will illuminate to show which page you are on. All your camera control panel
settings are available via these pages.
165Using ATEM Camera Control Panel
To Next Page
Loading...
Need help?
General
