Transitions The transitions palette is where you can configure the parameters of each
transition style. Forexample, for the dip transition the palette has a menu
where you can select the dip source and for the wipe transition the palette
displays all the available wipe patterns. There are lots of variations of
transitions and a large number of transitions can be created by combining
settings and features in the transitions palette.
NOTE It’s worth noting that selecting a specific style of transition in this palette will
only adjust the settings for these transitions, and you still need to select the style of
transition you want to perform in the transition control section on the software or ATEM
Mini’s control panel. The software and ATEM Mini’s control panel work together and
mirror all settings, so you can use any combination you like!
Downstream Key ATEM Mini has a downstream keyer which can be configured from the
downstream key palette. The palette has menu boxes for selecting the fill and
key signals to the keyer, plus sliders to set the pre multiplied key clip and gain
values, and mask settings.
Fade to Black The fade to black palette is where you can set the fade to black transition rate.
An ‘Audio Follow Video’ checkbox is also provided as a shortcut for the audio
mixer’s master fader AFV button. Selecting this feature lets you fade your
audio with your fade to black.
Media Player Tab
The ‘media player’ tab contains controls for your ATEM Mini’s media player and connected
HyperDecks.
Media Player Your ATEM Mini has a media player that plays back the stills that are stored in
the media pool memory built into the switcher. The menu list is used to select
the still that will be played or made available on the media player input to the
switcher.
Hyperdecks You can connect up to 4 Blackmagic HyperDeck Studio model disk recorders
and control them using ATEM Software Control’s HyperDecks palette.
For more information refer to the ‘HyperDeck Control’ section of this manual.
47ATEM Software Control
To Next Page
Loading...
Need help?
General
