In cut bus mode, pressing an input button will instantly switch it to air
Program Preview
In program preview mode, switching a source is a two step process. This is because pressing
an input button puts the source in a preview state so you can decide whether you want to
switch it, or perhaps select a different input source. This powerful switching mode is used by
professional broadcast switchers across the world.
TIP If you connect an HDMI monitor, for example Blackmagic Video Assist, to ATEM
Mini’s HDMI output you can output the preview signal and monitor the selected input
before switching it to air. For more information, refer to the ‘setting the HDMI output
source’ section later in this manual.
39ATEM Software Control
To Next Page
Loading...
