Brother BAS-311F-0 - Page 112

Programmer 111
Chapter 2 Programming with Help Function
2. Set the attribute.
3. Press after setting.
The screen returns to the confirmation screen.
Setting the attribute (feed data)
1. Move to the desired needle position and press .
The attribute setting screen appears.
2. Set the attribute.
3. Press after setting.
The screen returns to the confirmation screen.
Option output
Press
to mark with O.
Slow conversion
Press for type
selection.
Press for type selection.
Option output
Press
to mark with O.
Thread breakage ON/OFF
Press to select
ON/OFF.