Brother BAS-311F-0 - Page 113

112 Programmer
Chapter 2 Programming with Help Function
Setting the attribute (split data)
1. Move to the desired needle position and press .
The attribute setting screen appears.
2. Set the attribute.
3. Press after setting.
The screen returns to the confirmation screen.
Setting the attribute (trigger data) (BAS-300 Series)
1. Move to the desired needle position and press .
The attribute setting screen appears.
2. Set the attribute.
3. Press after setting.
The screen returns to the confirmation screen.
Stoppage of the needle at the lower end
Press
to select ON/OFF.
Machine stop
Press
to select ON/OFF.
Extended option output trigger
Press
or
-
to select the number.