Brother MFC-8220 - Fixing Unit

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-36
3.14 Fixing Unit
(1) Disconnect the heater harness and thermistor harness.
(2) Remove the bind B M4x12 Taptite screw and the shoulder screw, and then remove the
fixing unit.
Fig. 4-63
(3) Remove the three cup B M3x10 Taptite screws, and then remove the FU front paper
guide from the fixing unit.
Hint:

Regarding the proper mounting orientation of the FU front paper guide, please refer to
Fig. 4-62. Be sure not to mount it upside down.

Fig. 4-64
Pin
Pins
FU front paper guide
Taptite, cup B M3x10
Fixing unit
Fixing unit
Thermistor harness
Heater harness
Taptite, bind B M4x12
Shoulder screw