Brother MFC-8220 - Page 187

MFC-8220
SERVICE MANUAL
6-9
Error
Code
(Hex)
Error factor Check:
D*
Modem error.
• Main PCB
E4
Out of paper.
• Regist sensor
• Main PCB
E6
Write error in EEPROM.
• Driver PCB
E8 Data scanning error during transmission.
EA Document removed at phase B.
• CIS
• Main PCB
F5
EOL not found during page memory
transfer.
• Replace the main PCB if this error
occurs frequently.
F6
PC interface error.
• Interface cable
• Main PCB
FA Not used. (Scanner motor error detected.)
• Scanner motor
FF
Memory management error.
• Replace the main PCB if this error
occurs frequently.