Burford 2000 - Page 7

vii
CHAPTER 5: TIMING AND ADJUSTMENTS 70
 Bag Switch Adjustment 70
 Holder Shear Adjustment 71
 Shuttle Bar Alignment 72
 Gathering Belts Tension Adjustment 73
 Gathering Belts Speed Adjustment 74
 Belt Guide Tension Adjustment 75
 Gathering Belts Teeth Mesh 75
 Proximity Sensor Adjustment 76
 Proximity Sensor Adjustment, cont’d 77
 Gathering Brush Tension Adjustment 78
 Gathering Brush Air Adjustments 79
 Ribbon Dispenser Adjustment 79
 Ribbon Dispenser Adjustment, cont’d 80
 Ribbon Dispenser Adjustment, cont’d 81
 Needle Roller Replacement 82
 Needle Roller Replacement, cont’d 83
 Spacing of Twister Hook Shaft to Tip Of Holder Shear 84
 Adjusting Tie Tightness 85
 Nominal Adjustment 86
 Adjusting the Eccentric Ribbon Guide 86
 Adjusting the Belt Pulley 86
 Auxiliary DIP Switch Settings 87
 CPU DIP Switch Settings 88
 Fuse And Circuit Breaker List 89
 Counter Output 90
 PROM Replacement 90