2
Tap <DHCP>.
If you do not want to use DHCP to assign an IP address
● Tap <Off>. If you select <DHCP> when this service is unavailable, the machine will waste time and
communications resources searching the network for this service.
3
Check that <Auto IP> is set to <On>.
● If <Off> is selected, change the setting to <On>.
4
● IP addresses assigned via DHCP override the address obtained via Auto IP.
Manually entering an IP address
1
Check that <Auto Acquire> is set to <Off>.
● If <On> is displayed, tap <Auto Acquire>, and set both <Select Protocol> and <Auto IP> to <Off>.
2
Tap <Manually Acquire>.
3
Specify the IP address, subnet mask, and gateway address (or default gateway).
● Specify the settings in the following order: <IP Address> <Subnet Mask> <Gateway Address>.
● Enter each setting using the numeric keys, and tap <Apply>.
Network
438
To Next Page
Loading...
