For more information, see …
DescriptionItem
Restricted Data Rate is set
in the Cisco Unified
Communications Manager
Administration, and cannot
be set from the phone. The
phone displays the current
setting.
Note
Enables or disables the restriction of
the upstream and downstream PHY
rates according to Cisco Compatible
Extension (CCX) V4 Traffic Stream
Rate Set IE (S54.2.6). The default is
disabled.
Restricted Data Rate
WLAN Security
Set Up Advanced Profile Settings, on page
94
Assigns the security modeSecurity Mode
Controls whether the wireless
security credential data can be
exported in the configuration file.
•
True: Allows exporting the data
•
False: Blocks exporting the data
Export Security
Credentials
Wireless Security Credentials
Set Up Username and Password, on page
83
Assigns the network authentication
username for this profile
Username
Assigns the network authentication
password for this profile
Password
Available only for Network
Profile 1.
Note
If enabled, then the user must enter
the password when powering on the
phone.
If disabled, the password is saved to
the phone memory, and the user does
not need to enter the password when
powering on the phone.
Prompt Mode
WPA Pre-shared Key Credentials
Pre-Shared Key Setup, on page 83Determines the key type: Hex or
ASCII
Pre-shared Key Type
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
77
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Web Pages
Network Profile Settings