Cisco 7925G Administration Guide

For more information, see …
DescriptionItem
TFTP
Set Up Alternate TFTP Server, on page 93Enables automatic assignment of
TFTP servers
Obtain TFTP Servers
Automatically
Assigns static TFTP server IP
addresses to:
•
TFTP Server 1
•
TFTP Server 2
Use the following
TFTP servers
TSPEC Settings
Set Up Advanced Profile Settings, on page
94
Minimum data rate that outbound
traffic uses. Modify this setting when
Call Admission Control (CAC) is
enabled.
Cisco APs support only
PHY rates of 6, 11, 12, or
24. The default is 12. If you
use an access point that uses
802.11b, the PHY rate must
be configured to the
supported rate.
Note
Minimum PHY Rate
Excess bandwidth beyond application
requirements
Surplus Bandwidth
802.11G Power Settings
Set Up Advanced Profile Settings, on page
94
Assigns the channelsChannel
Enabled: Identifies enabled channels
in WLAN to improve scanning for
the phone.
Status
Sets the maximum transmit power
for the phone
MaxTxPower
802.11A Power Settings
Set Up Advanced Profile Settings, on page
94
Assigns the channelsChannel
Enabled: Identifies enabled channels
in WLAN to improve scanning for
the phone
Status
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
79
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Web Pages
Network Profile Settings

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g