Clear-Com HelixNet Partyline - Page 125

HelixNet | User Guide
l Enable (or disable) beltpack vibration when a call signal is received.
l Enable (or disable) the USB flasher mode for the beltpack.
l Tip: For a quick reference to the keysets on the beltpack, see HBP-2X user controls (front
and side view) or HXII-BP-X4 Beltpack user controls (top view).
8.5.1 Assigning Channels
You can assign any two available Channels to the beltpack (including the same Channel to both
keysets).
To assign a Channel:
1. In Beltpack Settings select Left Channel or Right Channel.
2. Select one of the available Channels (or none):
3. To confirm the selected setting, press the right-hand Call key.
8.5.2 Setting Talk Key Latching
To enable (or disable) Talk key latching:
1. In Beltpack Settings select Right Talk Latch or Left Talk Latch
2. Select one of the following:
l Latching (default)
l Non-Latching
l Disabled
Note: The setting applies to both Channels on the beltpack.
3. To confirm the selected setting, press the right-hand Call key.
8.5.3 Setting USB Flasher Mode
To enable (or disable) USB Flasher mode
1. In Beltpack Settings select either Left Keyset or Right Keyset
2. Select USB Flasher
3. Select one of the following:
l Disabled (default)
l Blinking
Page 125