HelixNet | User Guide
When restoring configuration from an external file, clicking on the red Restore Channels / Roles
button will allow you to navigate to the location of the saved file. The file has a .cca extension.
Select the file to restore it. If the restore is successful you will see a ‘successfully restored’
message.
Save All Saves your whole configuration; Main Station, Remote Stations, Speaker Stations,
roles/Channel names to the USB for future use. This option also saves 2-wire and 4-wire port
settings and assignment. Network settings (including Linking and Expansion) are NOT saved.
Restore Roles / Channels will restore Channel names and role configuration only.
To Restore All you must use the Main Station front panel menus. See Saving and Restoring the
Software Settings on page 100for details.
14.7 Linking Page
This is where the linking mode of the HelixNet Main Station is set to either Link-Master or, if
connecting to a Link-Group, Link-Member. When linking a Link-Member to a Link-Master you will
provide the device with the Link-Master IP or Hostname in this page. If you wish to re-configure a
Link-Group, you will change the link status of the device in this page, which will have the effect of
removing it from the group.
Note: A device’s Hostname is available in the General page of the CCM
Page 160
To Next Page
Loading...
