HelixNet | User Guide
12.2 Entering and Exiting Menu Mode
Use Menu mode to:
Configure the settings for the Beltpack, including Channel and audio settings.
Monitor beltpack performance and diagnose issues.
To enter Menu mode, press the Menu key. To exit Menu mode, press the Menu key again.
For more information about using Menu mode on the beltpack, see Configuring and
managing the beltpacks from front menus.
For information on changing the beltpack IP address, see Change the IP address of a
HelixNet device from the front menu screens
12.3 Adjusting the Program Feed Volume Level
To adjust the listen level (volume) of the Program Feed to the beltpack, use the up and down
controls on the front of the beltpack. See HXII BP X4 Beltpack.
Use the up arrow control to increase the listen level (volume), and use the down arrow control to
decrease the listen level (volume).
While the listen level is adjusted, the listen level for the Program Feed replaces the standard
Channel information on screen.
The Main Station is used to assign the Program Feed to Channels. For more information, see
Assigning the Program Listen to a Channel.
12.4 Binaural Audio
The HXII-BP-X5 beltpack with 5-pin headset connector has a binaural audio adjustment for the
left and right earphone. This means that you can separately adjust the audio volume level in the left
and right earphone. To adjust the left or right hand earphone volume:
1. Press the OPT button on the beltpack.
2. Use the left and right rotary controllers to balance the volume of the left and right channels
respectively. Turn the rotary control clockwise to balance the volume to the right ear, and
counter-clockwise to balance the volume to the left ear. The current balance level for each
Channel is shown on screen.
Page 145
To Next Page
Loading...
