HelixNet | User Guide
b. Select either of the following types of mic.
n Electret (-15 dB)
n Dynamic (0 dB) (default)
n Dynamic (low). This setting corresponds to -10 dB gain on HBP-2X and -15 dB gain on
HXII-BP-X4.
Note: In electret mode, phantom power is provided for an electret mic. In dynamic
mode, no phantom power is provided. Mic input levels are also adjusted between the
different modes to suit the different mic types.
c. To confirm the selected setting, press the right-hand Call key.
8.4 Audio Settings for the Microphone
To configure the audio settings for the microphone:
1. In Menu mode, select Audio Settings.
Note
:
The Headroom setting is only available on the HBP-2X Beltpack
2. To select the Headroom:
a. From the third menu, select Headroom.
b. From the fourth menu, select one of the following:
n Normal (default)
n High
3. To enable or disable the Contour Filter:
a. From the third menu, select Contour Filter
b. From the fourth menu, select one of the following:
n Enabled
n Disabled (default)
8.5 Configuring the beltpack Settings
In Menu mode > Beltpack Settings, you can:
l Assign Channels to the left and right beltpack keysets (set of controls).
l Enable (or disable) Talk key latching.
Page 124
To Next Page
Loading...
