Clear-Com HelixNet Partyline - Configuring the Control IO

HelixNet | User Guide
To save the Channel label, press the rotary control.
5.4.2 Assigning the Program Listen to a Channel
To assign (or unassign) the Program Listen (Program Feed) to a Channel:
1. In Menu mode, select Channels and then the name of the Channel.
2. From the third menu, select Program Listen.
3. From the fourth menu, select either None, or choose from the list of available programs.
Note: The default is None.
4. To confirm the selected setting, press the rotary control.
Tip: When you assign the Program Listen to a Channel, PGM is displayed on the display screen
(under the listen level bar, to the left) for that Channel.
5.4.3 Assigning a GPO relay to a Channel
You can assign a relay that is triggered on receiving a call or detecting a talk on a Partyline
Channel. To assign (or unassign) a relay:
1. In Menu mode, select Channels and then the name of the Channel.
2. From the third menu, select GPO on Talk or GPO on Call.
3. From the fourth menu, select either None, or choose from the list of available relays.
Note: The default is None.
4. To confirm the selected setting, press the rotary control.
Note: A GPO Trigger initiated by a Program Audio Input VOX can on only be assigned to a GPO on the
same device.
5.5 Configuring the Control I/O
The Control I/O connector (25 way female D-type) on the rear panel allows you to connect up to 4
relay outputs or 4 opto inputs and control them through the Main Station keysets:
Page 82