Clear-Com HelixNet Partyline - Network - Powerline; Network - Ethernet

HelixNet | User Guide
l Channel Name (default)
l Hostname
l Role Name
l Blank
l Disabled
4. To confirm the selected setting, press the right-hand Call key.
8.7 Network - Powerline
Note: This section applies only to the HBP-2X Beltpack and the HXII-BP-X4 when powered by
powerline.
In Menu mode > Network, you can view the IP address of the beltpack:
1. In Menu mode, press the left-hand Call Key and then select Network.
8.8 Network - Ethernet
Note: This section applies only to the HXII-BP-X4 when powered over Ethernet.
In Menu mode > Networking, you can:
l See networking settings including DHCP, IP address, subnet mask and gateway.
l Pair to a Main Station.
8.8.1 Viewing Network Preferences
To view network preferences:
1. In Menu mode, select Networking > Preferences
You can view the following:
l DHCP enabled or disabled
l IP address
l Subnet Mask
l Gateway
8.8.2 Pairing to a Main Station
To pair to a Main Station:
Page 128