HelixNet | User Guide
Note: You can also configure and control HelixNet units using the front panel menu interfaces
on each unit. See:
Configuring and managing the Main Station from front menus
Configuring and managing the Remote Station from front menus
Configuring and managing the Speaker Station from front menus
Configuring and managing the beltpacks from front menus
Using the HBP-2X Beltpack
Using the HXII-BP-X4 Beltpack
Note: Some functionality (for example, creating Roles) is only available from the CCM.
14.1 Access the CCM
To access the Core Configuration Manager (CCM), enter the IP address of the HelixNet Main
Station, as displayed on the front panel, into the URL field of your browser. If the unit is reachable
over your network, this will take you to the Overview page of the CCM that is served by the unit.
14.1.1 CCM Password
CCM username: admin
CCM password:
The default unique password is based on the device serial number. To find the default password
navigate to: Front panel menu>Networking>CCM Access>Default password [unique
password].
The default unique password is available in the front panel menu of the device UNTIL you change
it in the CCM. If you change the password it is no longer available in the front panel menus. If you
lose the password you need to reset it from the front panel menu in order to gain access to the
CCM.
Change the CCM password from the default setting:
In the CCM, navigate to: Device>General>Change password.
Reset the CCM password from the front panel menus
Press the menu button on the main station. Navigate to: Administration>CCM Access>Reset
CCM Password.
Once you have reset the password, it is available for you to view under Networking in the front
panel menu.
Page 154
To Next Page
Loading...
