HelixNet | User Guide
Connect the Ethernet port on the Speaker Station to either the IP network in which
the HMS resides or directly to one of the Ethernet ports on the HMS.
2. Connect a headset or microphone to the Speaker Station.
3. If required, remove the connector from the optional power supply and connect the power
supply to the Power screw terminals on the Speaker Station.
3.4 Installing the HBP-2X Beltpacks
The HBP-2X Beltpack is a device that you can:
l Wear at your belt using the beltclip.
l Install to a shelf or other flat surface.
l Attach to a pole or other fixed upright position.
For more information, see HBP-2X beltclip, beltloops and feet (base view).
3.4.1 Power Up
The HBP-2X Beltpack is powered from the standard mic cable that connects the device with the
HMS-4X Main Station (see below).
3.4.2 Connecting the HBP-2X Beltpack to the Main Station
To connect the HBP-2X Beltpack to the Main Station:
1. There are two powerline connections on the Main Station which can each support up to 10
digital HBP-2X Beltpacks. There are two connectors (3-pin XLR, male and female) for each
line.
Connect the cable to the selected connector on the Main Station.
Note: For the location of Lines 1 and 2 (the powerlines) on the Main Station, see F & G in
diagram in HMS-4X Main Station: rear panel.
2. Connect the cable to the beltpack, using one of the two 3-pin XLR connectors (male and
female) on the base / rear of the beltpack.
For examples of topologies see Topologies.
3.5 Installing the HXII-BP-X4 Beltpacks
The HXII-BP-X4 Beltpack is a device that you can:
Wear at your belt using the beltclip.
Install to a shelf or other flat surface.
Page 62
To Next Page
Loading...
