HelixNet | User Guide
Once a role has been selected on a device, this role will persist over power cycles until a new role
is selected or the device is returned to factory settings.
Each device has the ability to operate a configuration local to that device (local config), or a
selected role that can be pre-configured in the CCM.
If a Role is edited in the device menus rather than the CCM, these changes will be reflected in the
CCM. The latest configuration change, whether this is made in the CCM or from the device will
dominate, neither interface has precedence.
Roles contain Roles do NOT contain
Audio settings Network settings (IP address, DHCP etc.)
Keyset Assignment Pairing information (HKB and HRM over IP)
Station settings Linking information (Link Master/Link Member)
Program feed assignment Expansion information (Host/Expanded panel)
GPIO configuration 2W/4W module assignment
13.2 Example Roles Set Up
The following tables give an example of how roles could be set up in a working scenario.
Device type Device hostname Roles available for
selection
Role selected by
device
Main Station main_station_1 Local config Director 1
Director 1
Director 2
Sound booth
main_station_2 Local config Sound booth
Director 1
Director 2
Sound booth
Page 147
To Next Page
Loading...
