HelixNet | User Guide
Type of reset Result of reset
Reset HMS
Reset Main Station, including Roles to factory
defaults. This option will also return the
CCM password to the factory default setting.
Reset Endpoints Reset the local configuration for beltpacks,
remote stations and speaker stations (Roles
are not reset)
Reset CCM Pass This option is only available when the CCM
password has been changed. You can use
this setting to reset the password to the default
setting.
Reset All Reset all devices; Roles and local
configuration.
Note: Reset HMS (factory settings) will erase any Role configurations you have made. Please
save Role configurations before doing this.
5.7.6 Manually Rebooting the Main Station
To manually reboot the Main Station:
1. In Menu mode, select Administration and then Reset.
2. The third menu select Reboot.
3. In the fourth menu, select Reboot Now.
When the rotary control is pressed, the display changes to Rebooting … for 2 seconds, and then
the Main Station reboots.
5.7.7 Saving and Restoring the Software Settings
Use this option to save your configuration to a USB stick or restore a previously saved file:
1. Insert a memory stick into the USB 2.0 (A) connector. See table in Main Station/Remote
Station: Front panel
2. In Menu mode, select Administration and then Settings.
3. To save, in the third menu, select Save All. Once you select Save you should not remove the
USB stick right away. Depending on the USB stick it might take up to 5 seconds to complete.
4. To restore all HMS settings, in the third menu, select Restore all.
Page 100
To Next Page
Loading...
