COMBA CriticalPoint V3 7 BDA - Page 136

CRITICALPOINT 700/800MHZ BDA/DAS/BBU V3 USER MANUAL
©2024 Comba Telecom. All Rights Reserved.
568 Gibraltar Drive, Milpitas, CA 95035 | +1 408 526 0180
Rev. 1-0-2 Rev. Date: 11-1-2024
Page: 136
Table 17: External Annunciator Panel WEB GUI Settings Explanation
Parameter name
Description
AP Temperature
Current device temperature
AP Over Temperature Threshold
Device will alarm if above this temperature threshold. Modify
if desired. Default setting recommended.
Firmware Version
Current Firmware Version loaded on the device
Serial Number
Device Serial Number
Overtemperature Alarm
Disable/Enable Overtemperature Alarm. Modify if desired.
Default setting recommended.
Communication Fault Alarm
Disable/Enable Communication Fault Alarm. Modify if
desired. Default setting recommended.
Communication Alarm Detection
Duration(10s)
Allowable time without communication before
Communication Fault Alarm. Set in Multiples of 10 seconds.
The default setting is 12. 12 x 10 seconds = 120 seconds or
2 minutes
Buzzer Switch
Enable/Disable Buzzer. Modify if desired. Default setting
recommended.
End of Section