0.12 AUTHORIZED EQUIPMENT OPERATORS
Signal Boosters/Zone Enhancers (Also referred to BDAs or Fiber Fed BDAs) are not consumer devices. They
are industrial devices which may only be operated and maintained by authorized individuals and qualified
installers.
1. Operators of the equipment MUST have taken and passed Comba Telecom’s certification
training for RF101 and the V3 BDA/DAS/BBU product line.
2. Operators of the equipment MUST have a valid FCC General Radio Operator License (GROL) if
operating the device in the USA.
3. Operators of the equipment MUST have NICET Level 3 Certification IB-PSC; or they MUST have
NICET Level 2 Certification IB-PSC and be supervised by someone who has NICET Level 3 IB-
PSC if operating the device in the USA.
4. Installers of the equipment MUST have NICET Level 2 Certification IB-PSC or higher; or they
MUST have NICET Level 1 Certification IB-PSC and be supervised by someone with NICET Level
2 Certification IB-PSC or higher while operating the device in the USA.
5. Non-Licensee Operators MUST receive express written consent to operate the Signal
Booster/Zone Enhancer from the FCC/ISED License Holder BEFORE installing and operating
the device.
The equipment must be installed and operated in accordance with any license required by the radio authorities
in the country of concern. In most cases, it is a criminal offense if one fails to obtain a license to install and
operate the equipment. It is the operator’s responsibility to ensure that any required licenses are obtained, that
systems are installed and commissioned in accordance with their terms, and that no changes can be made
later that would disobey them.
Comba reserves the right to seize sales to a client and/or report the violation to the proper authorities should
we determine if a client is allowing unauthorized individuals to operate the equipment. Comba will not be held
responsible for unauthorized use of our devices.
End of Section
To Next Page
Loading...