3.10 WEB GUI LOGIN AND USER MANAGEMENT
The V3 BDA/MU/RU and V2 FOU devices can be monitored and controlled via the WEB GUI; use the
following instructions to login to the GUI for system parameter setting and commissioning.
BDA/MU or RU Login
• Set the computer IP address to 192.168.8.xxx (except 101) / 255.255.255.0. (e.g. 192.168.8.100)
• Connect the computer to the OMT Port on the device using a regular Ethernet RJ45 Cable.
• Use the default device IP address of http://192.168.8.101 in the browser to login to the device.
Enter full address with the <http://> all the time. Some browsers will default to use <https> and not be
able to access the device if just typing 192.168.8.101.
• Use username admin and password admin for general web operation.
• There is an additional LAN port located on the BDA/MU only. The LAN port can be used for local
access but more commonly used for remote access after being configured to connect to an external
Modem / Router / Switch or a Gateway, etc...
The LAN port IP can be configured in WEB –> Management –> Network.
The LAN port default IP address is 192.168.0.101 / 255.255.255.0, and the Gateway is 192.168.0.1.
Note: If the device is configured for remote connection using the LAN port, all the firmware
upgrades for the BDA/MU, FOU, and RUs can be completed remotely through the BDA/MU
without the need to send anyone to the site.
FOU Login
• Set the computer IP address to 192.168.8.xxx (except 101) / 255.255.255.0. (e.g. 192.168.8.100)
• Connect the computer to the OMT Port on the device using a regular Ethernet RJ45 Cable.
• Use the default device IP address of https://192.168.8.101 (Must use https://) in the browser to
login to the device. Enter full address with the <https://> all the time for the FOU. If you receive any
security warnings from the web browser, they can be ignored.
• First-time login: Use username admin and password admin for general web operation. If using an
older FW version, the system may prompt you to set a new password. Change the password and
notate accordingly.
Note: use admin/Admin12345678 if admin/admin does not work.
To Next Page
Loading...