0.10 SAFETY NOTICES AND ADMONISHMENTS
This document contains safety notices in accordance with appropriate standards. In the interests of conformity
with the territory standards for the country concerned, the equivalent territorial admonishments are also shown.
Installation, adjustment, maintenance, and/or repair of the equipment must only be conducted by
trained/certified personnel! At all times, personnel must comply with any safety notices and
instructions! Before installing, modifying, or replacing any of the equipment, the user manual should
be read and understood in its entirety.
Specific hazards are indicated by symbol labels on or near the affected parts of the equipment. The labels
conform to international standards, are triangular, and are colored black on a yellow background. An
informative text label may accompany the symbol label.
Hazard labeling is supplemented by safety notices in the applicable sections of this manual. These notices
contain additional information on the nature of the hazard and may also specify precautions.
Example:
For compliance with the general population RF exposure limits, each individual antenna
used for this transmitter must be installed to provide a separation distance during
normal operation and must not be co-located with any other antenna for meeting RF
exposure requirements.
Warning Notices:
These draw the attention of personnel to hazards that may cause death or injury to the operator or others.
Examples of use are cases of high voltage, laser emission, toxic substances, point of hot temperature, etc.
Example:
WARNING. Electric Shock may occur if the signal booster is installed near water.
Alerts:
These draw the attention of personnel to hazards that may cause damage to the equipment.
Examples:
ALERT! Disconnection of either of the RF ports (unloaded) may cause damage to the
equipment when power and equipment is active.
To Next Page
Loading...