©2025 Copeland LP.
026-1803 R13 Supervisor I&O User Guide 8 - 1
8 Site Supervisor Displays
8.1 10.1-Inch Touchscreen Display
The Site Supervisor 10.1-Inch Display
(P/N 818-7240) is a remote user interface for the Site
Supervisor that connects to the controller using the Ethernet
network through the Ethernet port. The Site Supervisor UI
allows users to perform critical actions in the controller
quickly. Functions such as lighting overrides, controlling
heating and cooling stages, status information, and viewing
alarms can all be performed using the 10.1-Inch Display.
Site Supervisor 10.1-Inch Display Quick Start Guide P/N 026-
4045.
8.1.1 Display Connections
Figure 8-1 - Site Supervisor 10.1-Inch Display
WARNING
WARNING! The Supervisory Displays should not be used for purposes different from those
described in this manual.
• Displays cannot be used as a safety device.
• When using an external power supply, it is necessary to separate the power of the device from the rest of
the electrical devices connected inside the electrical panel.
• Disconnect all electrical connections before any kind of maintenance is performed.
• Do NOT open the Supervisory Display. Do NOT open the panel rear cover when power is applied. Check
that the supply voltage is correct before connecting.
• Do not expose to water or moisture: use the controller only within its operating limits to avoid sudden
temperature changes with high atmospheric humidity to prevent condensation.
• Wire polarity must be observed: a wrong connection may cause possible malfunctioning and damage to
the controller or Displays.
Figure 8-2 - Display Connections for 10.1-Inch Display
To Next Page
Loading...