©2025 Copeland LP.
026-1803 R13 Supervisor I&O User Guide 8 - 8
3. Once you have connected the network cable to the Site Supervisor and 21.5-Inch Display, press the menu icon and
then press the browser icon . You will now have access to the Site Supervisor through the 21.5-Inch Display.
Note: If the Site Supervisor has already been set up, you can skip steps 4-6 and log into your Site Supervisor. If this is
the initial setup of the Site Supervisor, continue following the steps to set up the Site Supervisor.
4. Once you have accessed the Site Supervisor via the 21.5-Inch Display, you will be prompted to log in. The username will be
“user” and the password will be “pass.”
Note: Look at the lower right of the screen to see the version of the Site Supervisor. If the version is 2.06 or above, you
will be prompted to change the password.
5. Once you have changed the password, you will be on the Localization menu in the Setup Wizard. Press the Next arrow key
at the top right of the screen.
6. This will take you to the General Setup Parameter where you will need to enter a Site Name. Once the Site Name has been
entered, you will be able to log into the Site Supervisor.
8.4 Site Supervisor Touchscreen Display Version Compatibility
Note: For complete product part numbers and accessory ordering information, contact your Copeland Sales representative or
Customer Service.
Table 8-4- Site Supervisor Touchscreen Display Support Matrix
Site Supervisor Version
Touchscreen Display Part
Number
Touchscreen Display Version 2.08F01 and Below 2.10F01 and Above
818-9022
818-9023
4.3-Inch x
818-7240 10.1-Inch
818-7241 15.6-Inch
818-7242 21.5-Inch
To Next Page
Loading...