DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
94
Figure 5-18 Configure VLAN Interface - Hybrid window
The fields that can be configured are described below:
Parameter Description
VLAN Mode
Select the VLAN mode option here. Options to choose from are
Access, Hybrid, and Trunk.
Acceptable Frame
Select the acceptable frame behavior option here. Options to choose
from are Tagged Only, Untagged Only, and Admit All.
Ingress Checking
Select the check box to enable or disable the ingress checking
function.
Native VLAN
Tick this option to enable the native VLAN function.
VID After ticking the Native VLAN check box, this option will be available.
Enter the VLAN ID used for this configuration here. This value must be
between 1 and 4094.
Action
Select the action that will be taken here. Options to choose from are
Add, Remove, Tagged, and Untagged.
Add Mode Select whether to add an Untagged or Tagged parameters.
Allowed VLAN Range
Enter the allowed VLAN range information here.
Click the Apply button to accept the changes made.
Click the Back button to return to the previous window.
When Trunk was selected as the VLAN Mode, the following page will appear.
Figure 5-19 Configure VLAN Interface - Trunk window
To Next Page
Loading...
