DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
356
Port
Select the port used for the configuration here.
Action
Select the action that will be taken here. Options to choose from are
Add and Delete.
Type Select the type of voltage threshold. Options to choose from are Low
Alarm, Low Warning, High Alarm, and High Warning.
Value
Enter the threshold value. This value must be between 0 and 6.55 Volt.
Click the Apply button to accept the changes made.
DDM Bias Current Threshold Settings
This window is used to configure the threshold of the bias current for specific ports on the Switch.
To view the following window, click OAM > DDM > DDM Bias Current Threshold Settings, as show
below:
Figure 10-5 DDM Bias Current Threshold Settings window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
Port
Select the port used for the configuration here.
Action
Select the action that will be taken here. Options to choose from are
Add and Delete.
Type
Select the type of bias current threshold. Options to choose from are
Low Alarm, Low Warning, High Alarm, and High Warning.
Value
Enter the threshold value. This value must be between 0 and 131 mA.
Click the Apply button to accept the changes made.
DDM TX Power Threshold Settings
This window is used to configure the threshold of TX power for specific ports on the Switch.
To view the following window, click OAM > DDM > DDM TX Power Threshold Settings, as show below:
To Next Page
Loading...
