DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
85
Figure 5-5 MAC Address Table window
The fields that can be configured are described below:
Parameter Description
Port
Select the switch unit and the port that will be used for this
configuration here.
VLAN ID
Enter the VLAN ID that will be used for this configuration here.
MAC Address
Enter the MAC address that will be used for this configuration here.
Click the Apply button to accept the changes made.
Click the Clear Dynamic by Port button to clear the dynamic MAC address listed on the corresponding
port.
Click the Clear Dynamic by VLAN button to clear the dynamic MAC address listed on the corresponding
VLAN.
Click the Clear Dynamic by MAC button to clear the dynamic MAC address entered.
Click the Find button to locate a specific entry based on the information entered.
Click the Clear All button to clear all dynamic MAC addresses.
Click the View All button to display all the MAC addresses recorded in the MAC address table.
MAC Notification
This window is used to view and configure MAC notification.
To view the following window, click L2 Features > FDB > MAC Notification, as shown below:
To Next Page
Loading...
