DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
153
Figure 7-5 Port Rate Limiting window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the appropriate port range used for the configuration here.
Direction Select the direction option here. Options to choose from are Input and
Output. When Input is selected, the rate limit for ingress packets is
configured. When Output is selected, the rate limit for egress packets
is configured.
Rate Limit
Select and enter the rate limit value here.
When Bandwidth is selected, enter the input/output bandwidth value
used in the space provided. This value must be between 64 and
10000000 kbps. Also, enter the Burst Size value in the space
provided. This value must be between 0 and 128000 kilobytes.
When Percent is selected, enter the input/output bandwidth
percentage value used in the space provided. This value must be
between 1 and 100 percent (%). Also, enter the Burst Size value in
the space provided. This value must be between 0 and 128000
kilobytes.
Select the None option to remove the rate limit on the specified port(s).
The specified limitation cannot exceed the maximum speed of the
specified interface. For the ingress bandwidth limitation, the ingress
can trigger a pause frame or a flow control frame when the received
traffic exceeds the limitation.
Click the Apply button to accept the changes made.
Queue Rate Limiting
This window is used to view and configure the queue rate limiting settings.
To Next Page
Loading...
