D-Link DGS-1510 Series - Ipv6 Neighbor

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
146
Figure 6-14 IPv6 Interface - Detail, Interface IPv6 Address window
Click the Restart button to restart DHCPv6 client on an interface.
The fields that can be configured for DHCPv6 Client Settings are described below:
Parameter Description
Client State
Select this option to enable or disable the DHCPv6 client state. Tick
the Rapid Commit check box to proceed with two-message exchange
for prefix delegation.
Click the Apply button to accept the changes made.
IPv6 Neighbor
This window is used to configure and view the IPv6 neighbor settings.
To view the following window, click L3 Features > IPv6 Neighbor, as shown below:
Figure 6-15 IPv6 Neighbor window
The fields that can be configured are described below:
Parameter Description
Interface VLAN
Enter an interface VLAN ID.
IPv6 Address
Enter the IPv6 address.
MAC Address
Enter the MAC address.
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Clear button to clear all the information for the specific port.
Click the Clear All button to clear all the information in this table.