DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
139
Click the Edit button to re-configure the specific entry.
ARP Table
This window is used to view and configure the ARP table settings.
To view the following window, click L3 Features > ARP > ARP Table, as shown below:
Figure 6-4 ARP Table window
The fields that can be configured are described below:
Parameter Description
Interface VLAN
Select and enter the interface’s VLAN ID used here. This value must
be between 1 and 4094.
IP Address
Select and enter the IP address to display here.
Mask After the IP Address option was selected, enter the mask address for
the IP address here.
Hardware Address
Select and enter the MAC address to display here.
Type Select the type option here. Options to choose from are All and
Dynamic.
Click the Find button to locate a specific entry based on the information entered.
Click the Clear All button to clear all the information.
Click the Delete button to remove the specific entry.
Gratuitous ARP
This window is used to view and configure the gratuitous ARP settings. A gratuitous ARP request packet
is an ARP request packet where the source and the destination IP address are both set to the IP address
of the sending device and the destination MAC address is the broadcast address.
Generally, a device use the gratuitous ARP request packet to discover whether the IP address is
duplicated by other hosts or to preload or reconfigure the ARP cache entry of hosts connected to the
interface.
To view the following window, click L3 Features > Gratuitous ARP, as shown below:
To Next Page
Loading...
