DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
151
weight is replenished. When weights of all CoS queues reach 0, the
weights get replenished at a time.
Click the Apply button to accept the changes made.
Queue Settings
This window is used to view and configure the queue settings.
To view the following window, click QoS > Basic Settings > Queue Settings, as shown below:
Figure 7-3 Queue Settings window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the appropriate port range used for the configuration here.
Queue ID Enter the queue ID value here. This value must be between 0 and 7.
WRR Weight
Enter the WRR weight value here. This value must be between 0 and
127. To satisfy the behavior requirements of Expedited Forwarding
(EF), the highest queue is always selected by the Per-hop Behavior
(PHB) EF and the schedule mode of this queue should be strict priority
scheduling. So the weight of the last queue should be zero while the
Differentiate Service is supported.
WDRR Quantum
Enter the WDRR quantum value here. This value must be between 0
To Next Page
Loading...
