DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
127
LLDP State is disabled and LLDP Forward Sate is enabled, the
received LLDPDU packet will be forwarded.
LLDP Trap State
Select this option to enable or disable the LLDP trap state.
LLDP-MED Trap State
Select this option to enable or disable the LLDP-MED trap state.
Click the Apply button to accept the changes made.
The fields that can be configured for LLDP-MED Configuration are described below:
Parameter Description
Fast Start Repeat Count
Enter the LLDP-MED fast start repeat count value. This value must be
between 1 and 10.
Click the Apply button to accept the changes made.
The fields that can be configured for LLDP Configurations are described below:
Parameter Description
Message TX Interval
Enter the interval between consecutive transmissions of LLDP
advertisements on each physical interface. The range is from 5 to
32768 seconds.
Message TX Hold Multiplier
Enter the multiplier on the LLDPDUs transmission interval that used to
compute the TTL value of an LLDPDU. This value must be between 2
and 10.
Relnit Delay
Enter the delay value for LLDP initialization on an interface. This value
must be between 1 and 10 seconds.
TX Delay
Enter the delay value for sending successive LLDPDUs on an
interface. The valid values are from 1 to 8192 seconds and should not
be greater than one-fourth of the transmission interval timer.
Click the Apply button to accept the changes made.
LLDP Port Settings
This window is used to configure the LLDP port settings.
To view the following window, click L2 Features > LLDP > LLDP Port Settings, as shown below:
To Next Page
Loading...
