DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
42
Group Name
Enter the SNMP group name to which the user belongs. The syntax is
general string that does not allow spaces.
SNMP Version Select the SNMP version. Options to choose from are v1, v2c, and v3.
SNMP V3 Encryption When selecting v3 in the SNMP Version drop-down list, this option is
available. Options to choose from are None, Password, and Key.
Auth-Protocol When selecting v3 in the SNMP Version drop-down list, and selecting
either Password or Key in the SNMP V3 Encryption drop-down list,
this option is available. Select the authentication level. Options to
choose from are MD5, and SHA.
MD5 - Select to use the HMAC-MD5-96 authentication level. This field
will require the user to enter a password or a key.
SHA - Specify that the HMAC-SHA authentication protocol will be
used. This field will require the user to enter a password or a key.
Priv-Protocol When selecting v3 in the SNMP Version drop-down list, and selecting
either Password or Key in the SNMP V3 Encryption drop-down list,
this option is available. Select the private protocol. Options to choose
from are None, and DES56.
None - Specify that no authorization protocol is in use.
DES56 - Specify that DES 56-bit encryption is in use, based on the
CBC-DES (DES-56) standard. This field will require the user to enter a
password or a key.
IP Address-List Name
Enter the standard IP access control list (ACL) to associate with the
user.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specified entry.
SNMP Host Table Settings
This window is used to configure and display the recipient of the SNMP notification.
To view the following window, click Management > SNMP > SNMP Host Table Settings, as shown
below:
Figure 4-12 SNMP Host Table Settings
The fields that can be configured are described below:
Parameter Description
To Next Page
Loading...
