D-Link DGS-1510 Series - L2 Multicast Control

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
112
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the appropriate port range used for the configuration here.
Group ID
Enter the channel group number here. This value must be between 1
and 32. The system will automatically create the port-channel when a
physical port first joins a channel group. An interface can only join one
channel-group.
Mode Select the mode option here. Options to choose from are On, Active,
and Passive. If the mode On is specified, the channel group type is
static. If the mode Active or Passive is specified, the channel group
type is LACP. A channel group can only consist of either static
members or LACP members. Once the type of channel group has
been determined, other types of interfaces cannot join the channel
group.
Click the Add button to add a new entry based on the information entered.
Click the Delete Member Port button to remove the specific member port.
Click the Delete Channel button to remove the specific entry.
Click the Channel Detail button to view more detailed information about the channel.
After clicking the Channel Detail button, the following page will be available.
Figure 5-36 Port Channel window
Click the Edit button to re-configure the specific entry.
Click the Back button to return to the previous window.
L2 Multicast Control