D-Link DGS-1510 Series - Ipv6 Interface

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
144
The fields that can be configured are described below:
Parameter Description
IP Address
Select and enter the single IPv4 address here.
Network Address
Select and enter the IPv4 network address here. In the first space
enter the network prefix and in the second space enter the network
mask.
Connected
Select this option to display only connected routes.
Hardware
Select this option to display only hardware routes. Hardware routes are
routes that have been written into the hardware chip.
Summary
Display the brief information of the active routing entries.
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IPv6 Interface
This window is used to view and configure the IPv6 interface’s settings.
To view the following window, click L3 Features > IPv6 Interface, as shown below:
Figure 6-11 IPv6 Interface window
The fields that can be configured are described below:
Parameter Description
Interface VLAN
Enter the VLAN interface’s ID that will be associated with the IPv6
entry.
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Detail button to view and configure more detailed settings for the IPv6 interface entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Detail button, the following page will be available.