D-Link DGS-1510 Series - Firmware Backup to TFTP; Configuration Restore & Backup; Configuration Restore from HTTP

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
373
Figure 13-4 Firmware Backup to HTTP window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
Source URL
Enter the source filename and path of the firmware file located on the
Switch here. This field can be up to 64 characters long.
Click the Backup button to initiate the firmware backup.
Firmware Backup to TFTP
This window is used to initiate a firmware backup to a TFTP server.
To view the following window, click Tools > Firmware Upgrade & Backup > Firmware Backup to TFTP,
as shown below:
Figure 13-5 Firmware Backup to TFTP window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
TFTP Server IP Enter the TFTP server’s IP address here. When select the IPv4 option,
enter the IPv4 address of the TFTP server in the space provided.
When the IPv6 option is selected, enter the IPv6 address of the TFTP
server in the space provided.
Source URL
Enter the source filename and path of the firmware file located on the
Switch here. This field can be up to 64 characters long.
Click the Backup button to initiate the firmware backup.
Configuration Restore & Backup
Configuration Restore from HTTP
This window is used to initiate a configuration restore from a local PC using HTTP.